Q&A 100

Maintaining the correct pressure prevents pipe damage, protects appliances, and prevents catastrophic leaks or ruptures.

It exerts too much force on valves and connections, reducing their useful life and increasing the risk of pipe explosions.

Connecting a water pressure gauge to an outside hose bib to get an accurate reading.

It is a device in the main line that reduces the high inlet pressure to a safe level.

It may be due to a faulty PRV, hidden leak or problemás in the city main supply.

It is usually caused by a mineral-clogged aerator or a defective cartridge in that faucet.

Yes, calcification inside the pipes reduces the internal diameter, restricting water flow.

Cleaning the shower head in vinegar to remove scale or checking the reducing valve.

Yes, sediment buildup or corroded valves can restrict the flow of hot water.

It is recommended to check it at least once a year or if you notice changes in the flow.

Lasts on average between 8 and 12 years, depending on maintenance and water hardness.

They provide unlimited hot water, are more energy efficient and last up to 20 years.

It indicates that the inside of the tank is rusting and needs to be replaced soon.

It is a sacrificial rod that attracts corrosive minerals to protect the metal tank.

The noises are caused by sediment at the bottom of the tank that boils as the water heats up.

It is recommended to set it at 120°F (49°C) to prevent burns and save energy.

Yes, draining the tank annually removes sediment and prolongs the life of the equipment.

It could be a broken dip tube, excess sediment, or faulty elements.

Requires annual descaling with white vinegar to clean the heat exchangers.

No, it means that the internal pressure is too high or that the valve is defective.

If the bill increases, you hear water running or the meter spins when everything is turned off.

It is flexible plastic resistant to freezing, economical and quick to install.

Copper lasts 50+ years and is antimicrobial. PEX is flexible and economical. Both are excellent options.

Hard water, high water velocity, or chloramines in the municipal supply.

It is a noisy impact when closing a tap, solved by installing water hammer dampers.

Yes, they rust internally causing leaks, dirty water and low pressure.

It is to replace the entire old water distribution system with type L copper or PEX.

Insulating exposed pipes and leaving a slight drip on freezing nights.

Sulfur bacteria in heater or dry drains (waterless P-traps).

It is usually near the meter on the street or where the main pipe enters the house.

It occurs if the water in the 'P' trap has evaporated, allowing gases to enter.

Roots penetrate old pipes through small cracks looking for water and nutrients.

Do not pour grease or wet wipes, and use hair strainers.

No, they generate intense heat that corrodes and damages old plastic and metal pipes.

It is using fiber optics to diagnose underground problemás without having to dig.

It is replacing the underground sewer line without digging a trench across the entire yard.

Indicates a serious venting or blockage problem in the main line.

Prevents city wastewater from flowing back into the house in floods.

Every 1 to 3 years to completely clean grease and roots from the pipe walls.

The snake pierces the obstruction, hydro-jetting washes the pipe under pressure, leaving it like new.

This is usually a worn flapper that doesn't seal properly or a faulty fill valve.

You can waste up to 200 gallons a day, dramatically increasing your bill.

By old, low-flow toilets, or throwing away wet wipes and excess paper.

Yes, they do not disintegrate like paper and cause serious blockages in the system.

The wax ring underneath has failed and needs replacement to avoid rotting the floor.

Changing the internal cartridge or worn rubber seals behind the handle.

The shower head usually has a mineral-locked restrictor.

Prevents overflows if you forget to close the faucet with the cap on and helps drainage.

Turn off the water, unscrew the 'P' trap under the sink and retrieve it there.

The porcelain decades, but the internal components should be replaced every 5 to 7 years.

It's stuck. Use an Allen wrench on the bottom to manually turn it and unlock it.

Fat, oil, bones, celery, potato peelings, pasta or rice.

Grind ice cubes and citrus peels with cold water to clean it.

Always cold, so that the fats solidify and can be crushed without sticking.

Unscrew the aerator at the tip and clean out any mineral deposits.

Dirty filter or the drain hose to the disposal is blocked.

You need to change the ceramic cartridge or worn internal gaskets.

Prevents dirty water from draining back into the dishwasher.

Immediately close the shut-off valves below, or the main valve in the house.

Obstruction in the main pipe below the 'T' joint. A snake is required.

Water with high levels of calcium and magnesium, which causes scale and damages plumbing.

If you have white spots, dry skin and your heater is quickly damaged by scale.

The softener removes calcium (uses salt). The filter removes chlorine, chemicals and bad taste (uses carbon).

Filters at a molecular level, eliminating 99% of contaminants to have very pure drinking water.

Carbon every 6 months, RO membranes every 2-3 years depending on use.

They prevent scale build-up in pipes, but do not physically remove calcium from the water.

They are harmless micro-air bubbles. If it is rinsed from the bottom up, it is not dangerous.

Municipal disinfectants that corrode old pipes and require special filters to remove them.

In high temperatures yes. A whole house filter extends the life of the PEX system.

Generally yes, but old pipes can add metals. A kitchen filter is highly recommended.

Plunger, Teflon tape, adjustable wrench and small pipe wrench.

To shut off water in emergencies and prevent thousands of dollars in flood damage.

Turn off the main water valve and put the heater in 'Vacation' mode.

Traps grease before reaching the sewer; Mandatory in commercial kitchens.

Put dye in the tank; If it appears in the cup without flushing within 15 minutes, there is a leak.

Yes, they prevent overflows that damage foundations and French drain lines.

Yes, changing rubber hoses with braided steel every 5 years prevents severe flooding.

Disconnect it in winter or install frost-free valves that do not retain water.

Mix water to deliver a constant temperature, avoiding burns in the shower.

Clean debris annually and pour water to verify that it activates itself.

Gas leaks, active pipe breaks, or sewer blockage returning sewage.

1. Close the main valve. 2. Turn off nearby electricity. 3. Call the plumber.

Evacuate, do not turn on lights or cell phones and call PG&E or emergencies (911).

Total blockage in the main sewer line. Hydro-jetting is urgently needed.

Close the tank's cold water valve and cut off the gas or electricity supply to the equipment.

It usually covers unforeseen water damage to the structure, but not the repair of the pipe itself.

Use towels, open windows, turn on fans, and move wooden furniture and electronic equipment.

Yes, but only as a temporary patch. The vibration or pressure will eventually break it again.

Extremely dangerous and illegal in California without a CSLB license.

If the plug is within your property boundaries, you are responsible for the repair.

Wi-Fi valves (like Flo by Moen) that monitor the water and shut off the line by itself if they detect a leak.

Type L is thick for commercial underground uses. Type M is slim, for light indoor uses.

Lead is toxic and contaminates drinking water causing serious neurological damage.

Crimps copper fittings hydraulically, without flames or welding, creating a secure and immediate seal.

Instantly delivers hot water to showers without having to run the water waiting for it to heat up.

Yes, using networks of purple pipes and gray catchment, following strict ecological codes.

State water-saving standards mandate low-flow, high-efficiency models (1.28 GPM).

It uses room temperature to heat the water, being up to 3 times more efficient than a normal electric one.

Precise calculations to reduce material costs, metal recycling and implementation of ultra-low consumption systemás.

Because we fuse certified C-36 craftsmanship with Lean methods for seamless installations and zero waste.